FAV-A112 Red Crow Winder Type 12WDr
Type:
Action Figure
Series:
1:18
Release Date:
09/2024
SRP:
HKD $550.00
Description
The Red Crow Winder Type 12WDr is a lightweight SA allocated to the Red Crow Squadron, one of the Republic of Yamato’s Special Assault Units. It was created jointly by the Hiroshima Heavy Industry and the Pacific Terminal Ltd. (PTL). The PTL obtained advanced technologies and components from Europa while trading with the great powers through its global transportation network, but these technology blueprints were found to be somewhat outdated, using technology from Agurts and Omanga that was from a previous generation. Therefore, the Hiroshima Heavy Industry researchers designed an SA based on the demands of the Yamatoan military, suitable for urban warfare and pursuing enemies at high speeds. The Winder’s motion control system consists of dozens of motion sensing modules, allowing for an unprecedented degree of sensitivity for the SA’s movements. Given the incredible responsiveness of the machine, however, the pilots of the Red Crow Winder Type 12WDr have to undergo strict and grueling training, as taking the cockpit of this SA can be very physically demanding.

Where to buy?

Check with your hobby store for purchasing details

PIA CLUB

Manufacturer

Toys Alliance

Customer Service

[email protected]
Content
- Red Crow Winder Type 12WDr x 1 - Type Hanabi SA Submachine Gun x 2 - Type Kanae SA Combat Knife x 2 - Gear Buckle x 2
Additional Info
Material:
Plastic
Action figure size:
approx. H: 10.5cm
Packaging box size:
approx. H:14.6cm X W:21cm X L:9.2cm
Warning
THIS IS NOT A TOY, 16 YEARS+. Choking hazard - small parts. Not for children under 3 years old. This product is suitable for ages 16 and up. Please read these instructions carefully before you open the product. Some components are rather sharp and fragile, exercise care during unpacking and disposing. Some components are of limited movability and could be damaged if inappropriately twisted or bent. Please keep this product away from fire, heater or any place with high temperature to avoid deformation. Do not wipe the product with thinner, benzene, alcohol, etc. which could damage the surface or cause paint fading. The product may vary from the picture prototype.